Specifications

7-18
Setup Mode
The Setup Editor
The Controller Destination List
ThetablebelowcontainstheavailablevaluesfortheMIDICC(continuouscontroller)
destinations.PhysicalcontrollerscansendMIDIvaluestothesedestinationsinordertocontrol
theparametersofPC3LEprogramsorexternalMIDIequipment.InSetupmode,these
destinationscanbeassignedforeachcontrollerontheSetupEditor
Controllerspagewiththe
Destparameter,iftheDestTypeparameterissettoCtrl.Bydefault,MIDICCssentfrom
physicalcontrollersaresenttotheirzone’sprograminternally,andtotheMIDIandUSBoutson
theirzone’sMIDIchannel(tochangethesesettingsseeDestination on page 7‐6and
Channel on page 7‐7.)
InthePC3LE,MIDICCdestinationsarebestusedtocontrolexternalMIDIequipment.Ifyou
wanttocontrolaprogramparameter,settheDestTypeparametertoParamontheSetupEditor
Controllerspage.ThishasthesameresultassendingaMIDICCtocontrolaprogram
parameter,butsavesyoualotofsetupsteps(ParametersalsosendtheirownCCnumberstothe
MIDIandUSBoutportsbydefault.)IfMIDICCmessagesfordestinations0‐127aresentto
programsinternally,programswillonlyrespondtosomeoftheseCCdestinations.
Forcontrollermessages
senttoexternalequipmentviatheMIDIorUSBoutports,destinations
0‐127willonlyperformtheirnamedfunctioniftheexternalequipmenthasthecapabilitytodo
so.MostofthesenamedfunctionscorrespondtotheMIDIstandardforcontinuouscontroller
destinations.
ControllerDestinationnumberswhicharegreat erthan
127aresentasaPC3LE‐specific
protocol,andarethusnotsentasMIDIdatathroughMIDIorUSBoutports.MostPC3LE
programsrespondtothecontrollerdestinationsabove127,thoughsomelike163RiffOnor176
ShKeyNumrequireadditionalcircumstancesorsetup.
Controller
Number
Corresponding
Destination
Name
Description
0 OFF/Bank By default, when you enter 0 or Clear for the Destination
parameter, the destination will be assigned to OFF. To select
Bank as the destination, use the Alpha Wheel or -/+ buttons.
1 MWheel Default assignment for Mod Wheel
2 Breath Default assignment for breath controller in compatible synths.
3 MIDI 03 MIDI Controller 3
4 Foot Default assignment for continuous foot controller in
compatible synths.
5 PortTim Monophonic PC3LE programs respond to this Controller if
portamento is turned on
6 Data Almost all PC3LE programs have this Controller assigned to
filter frequency or brightness
7 Volume MIDI Volume
8 Balance MIDI Balance
9 MIDI 09 MIDI Controller 9
10 Pan MIDI Pan—programs which use PANNER their effect chain
will respond to real-time pan adjustments; all other programs
will respond on the next note start, see The Pan/Volume
(PAN/VOL) Page on page 7-26.
Table 7-1 Controller Destination List