Specifications

7-58
Setup Mode
The Setup Editor
ChangingprogramssendsaBendRangemessagewiththecurrentprogram’svalues.Sodoes
pressingPanic,whichisaquickwaytoresetyourPC3LEorMIDIslavesifyou’veuseda
controllertomodulatethebendrange.
ANoteAboutContinuousControllersandTheBENDPage:
UnlikethePitchWheel,
othercontinuouscontrollerssuchasaknobwillnotautomatically
returntotheoriginalcenterpitch.Thiscanmakeithardtoaccuratelyreturnthecontrollertoit’s
centerpositionbyhand.Inthesecases,itisusefultouseaseparatecontrollerforbendingonly
upordown.Forexample,
tohaveaknobonlybendup,useaknobwithanOffsetvalueof64
andaScalevalueof50%,andCurvesettoLinear.Thebottomoftheknobrangewillnowbethe
centerpitch,andthetopoftheknobrangewillbethetop
ofyourbendrange.Tohaveaknob
onlybenddown,useaknobwithanOffsetvalueof‐127andaSca levalueof150%,andCurve
settoLinear.Thetopoftheknobrangewillnowbethecenterpitch,andthebottomoftheknob
rangewill
bethebottomofyourbendrange.Seepage 7‐11formoreonsettingknobcontroller
parameters.