Specifications

14-20
Tutorials: Setup Mode
Assigning A Single Knob To Control Relative Volume In Different Zones
Scale Method
TheScalemethodmultipliesthevolumeofoneyourZonesbyapercentage.Thismeansthatthe
scaledZone’svolumewillalwaysbeacertainpercentdifferentthanthenonscaledZone.Unlike
theOffsetmethodwhichalwayssetsaspecificvalueofvolumedifference,theScalemethod
changesthevolume
differencebetweenZonesforeachnewvolumesetti ng.Usingascalevalue
ofmorethan%100canresultinvaluestruncatedto127iftheresultofscalingisgreaterthan127.
1. If you are not already in Setup mode, press the Exit button until you reach the ProgramMode page,
then press the Setup mode button, located with the mode buttons to the left of the display. This will
bring you to the Setup mode main page. Next, press 58 and then Enter on the alphanumeric pad to
select the setup 58 Piano & Pad (see below.) You can also select setups by using the - / + buttons or
Alpha Wheel.
2. With the setup 58 Piano & Pad selected in setup mode, press the Edit button on the front panel.
This will bring you to the CH/PROG page of the setup editor (see below.)
3. From the CH/PROG page, press the CTRLS soft button on the bottom of the screen (see above.)
This brings you to the Controllers page where you can view and assign physical controllers to
destinations for the current Zone.
4. On the Controllers page, use the Chan/Zone buttons
to the left of the display to select Zone 2 (see
below.) You can view the number of the selected Zone in the top right corner of screen.
Step 3