Specifications

Tutorials: Setup Mode
Assigning A Single Knob To Control Relative Volume In Different Zones
14-23
12. Now we will set a Scale value for Zone 3. On the Controllers page for Knob 1, Zone 3, use the
cursor buttons to select the Scale field. On the alphanumeric pad press 90 and then the Enter
button to enter 90% as a Scale value (see below.)
Knob1(labeledModonthefrontpanel)shouldnowcontrolthevolumeofthepadsonZones2
and3(ifnot,reviewtheprevioussteps.)Zone3willalwaysbeat90%thevolumeofZone2
becauseoftheScalevalueset
forZone3.Forexample,ifKnob1issendingavalueof127,Zone
2willbeatMIDIvolume127,whileZone3willbeatMIDIvolume114.Thevalue114isaresult
ofthevaluesentbyKnob1(127)multipliedbytheScalevalue
forZone3(90%or.90.)This
equation,Knob1valuex.90,iscalculatedforeverynewKnob1valuereceived.BecauseMIDI
onlysendsintegervalues,numbers totherightofthedecimalpointaredropped,soeven
though127x.90=114.3,only114issent.
13. To finish, press the
Exit button to the right of the display to exit the Setup Editor and save your
changes to this setup under a new ID#. SeeTheSetupEditorsectionatthebeginningofthis
chapterfordetailsonsavingwhenyouexittheSetupEditor.