Specifications

Program Mode
The Program Editor
6-23
Low Key (LoKey)
Thissetsthelowestactivenoteforthecurrentlayer.Thisparameter’svaluecannotbesethigher
thanthevalueforHiKey.ThestandardMIDIkeyrangeisC1—G9(0‐127).MiddleCisC4.
High Key (HiKey)
Hereyousetthehighestactivenoteforthecurrentlayer.This
parameter’svaluecannotbeset
lowerthanthevalueforLoKey.
Low Velocity (LoVel)
Withthisparameteryoudefinethelowestattackvelocityatwhichthelayerwillbeenabled
(generateasound).Thevaluesforthisparameterandthenextareexpressedinthestandard
musicaldynamicsmarkings,similartothevaluesavailable
forthevelocitymaps.Attack
velocitiesthatarebelowthisthresholdwillnottriggernotes.Ifyousetthisparameter’svalue
higherthantheHiVelvalue,thelayerwillnotplayatall.
High Velocity (HiVel)
Similarly,thiswillsetthehighestattackvelocityatwhichthelayerwillbeenabled.Attack
velocities
abovethisthresholdwillnottriggernotesinthislayer.
UsingLoVelandHiVel,youcansetupvelocityswitchingbetweenuptoeightlayers.Ifyou
needevenmore,youcandoitusingtheEnableandEnableSense(S)parameters(page 6‐24).
Low Velocity ppp to fff ppp
High Velocity ppp to fff fff
Bend Off, Key, All All
Trig Normal, Reversed Normal
Delay Control Control Source list Off
Minimum Delay 0 to 25 seconds 0
Maximum Delay 0 to 25 seconds 0
Layer Enable Control Source list On
Enable Sense
Enable Min
Enable Max
Normal, Reversed
± 127
± 127
Normal
64
127
Opaque Layer Off, On Off
Sustain Pedal Off, On, On2 On
Sostenuto Pedal Off, On On
Freeze Pedal Off, On On
Ignore Release Off, On Off
Hold Through Attack Off, On Off
Hold Until Sustain Off, On Off
Parameter Range of Values Default