Specifications

6-44
Program Mode
The Program Editor
Trigger
Thisdefinesthecontrolsourcethatstartsthecurrentlayer’sASRs.TheASRstartswhenthe
triggerswitchesfromofftoon.IftheTriggerparameterissettoON,aglobalASRstartsrunning 
immediatelywhenyouselectaprogramthatcontainsit.AlocalASRstartsrunningas
soonas
youtriggeranoteinthelayerthatcontainsit.SwitchcontrolsarebettersuitedforASRtriggers
becauseoftheirbinary(on/off)nature.AcontinuouscontrolwilltriggertheASRswhenits
signalvalueisaboveitsmidpoint.
Mode
ThisparametersetsthesustainsectionoftheASR.
TheASR’smodedetermineswhattheASR
doeswhenitfinishesitsattacksection.IftheModeparameterissettoNormal,theASRwillrun
directlyfromitsattacksectiontoitsreleasesection(nosustain).AtasettingofRepeat,theASR
willcyclethroughtheatt ackand
releasesections,thenloopforwardandcyclethroughagain
untiltheASR’striggerswitchesoff.IfthemodeissettoHold,theASRmainta insitspositionat
theendoftheattacksectionuntiltheASR’striggerswitchesoff.TheASRthengoesintoits
releasesection.Ifthe
ASR’striggerswitchesoffbeforetheattacksectioniscomplete,theASR
goesdirectlytoitsreleasesection.
Delay
WhentheASR’s triggerswitcheson,theASRwillstartimmediatelyifthisparameterissetto
zero.NonzerovalueswillcauseacorrespondingdelaybetweentheASRtriggerandthestart
of
theASR.
Attack
ThisdefineshowlongtheASRtakestorampupfromminimumtomaximumeffecton
whateverit’sassignedto.
Parameter Range of Values Default
Trigger Control Source List Off
Mode Normal, Hold, Repeat Normal
Delay 0 to 30 seconds 0 seconds
Attack 0 to 30 seconds 0 seconds
Release 0 to 30 seconds 0 seconds