Datasheet

Tutorials
Controlling Multiple Modules with a Single Setup
11-10
4. Let’s now set the following Zone-specific parameters thusly (note that “Unassigned
Number” means a MIDI controller number that is unassigned on the target Module):
Zone 1 Zone 2
Parameter Value Parameter Value
Channel 1 Channel 2
MIDI Bank 2 MIDI Bank 5
MIDI Program 3 MIDI Program 112
Low Key C6 Low Key F4
High Key G7 High Key B5
Foot Switch Destination 64 Mod Wheel Destination 1
Foot Switch Mode Momentary Mod Wheel Entry State 0
Foot Switch Entry State Off Mod Wheel Exit State 0
Foot Switch Exit State Off All Other Controller Destinations Unassigned
Number
All Other Controller Destinations Unassigned
Number
All Other Controller Entry States 0
All Other Controller Entry States 0 All Other Controller Exit States 0
All Other Controller Exit States 0
Zone 3 Zone 4
Parameter Value Parameter Value
Channel 3 Channel 4
MIDI Bank 3 MIDI Bank 0
MIDI Program 67 MIDI Program 23
Low Key C3 Low Key E1
High Key E4 High Key B2
Control Knob Function 1 Destination 7 Control Knob Function 1 Destination 7
Control Knob Function 1 Entry State 127 Control Knob Function 1 Entry State 127
Control Knob Function 1 Exit State 127 Control Knob Function 1 Exit State 127
All Other Controller Destinations Unassigned
Number
All Other Controller Destinations Unassigned
Number
All Other Controller Entry States 0 All Other Controller Entry States 0
All Other Controller Exit States 0 All Other Controller Exit States 0
5. Let’s now set the MIDI receive channels on each of the Modules in our rig. Note that
they will be same as the channels of their corresponding Zone:
Module Channel
Module 1 1
Module 2 2
Module 3 3
Module 4 4
6. Finally, let’s now save our newly-created Setup. Recall that the Save button is illuminated.
To save our Setup, press the Save button once. The Save button LED will blink to
indicate that a save operation is underway, and the User Bank LED will also be lit. The
default save location will be the next available location in the Setup User Bank. If all