Operating Instruction and Parts Manual for KPC160W PLATE COMPACTOR 12010 Dairy Ashford Road, Suite 160 Sugar Land, TX 77478 281-313-2506 • 800-469-4178
WARNING: To reduce the risk of injury, all operators and maintenance personnel must read and understand these instructions, before operating, changing accessories, or performing maintenance on our equipment. All possible situations can not be covered in these instructions. Care must be exercised by everyone using, maintaining or working near this equipment. INTRODUCTION Thank you for your selection for our equipment. We have taken care in the design, manufacture and testing of this product.
FIRE & EXPLOSION HAZARDS! PETROL is extremely flammable and explosive under certain conditions; ENSURE that the petrol is only stored in an approved storage container. DO NOT refuel the motor while it is in operation or hot. DO NOT refuel the motor in the vicinity of sparks, a naked flame or a person smoking. DO NOT over fill the fuel tank and avoid spilling petrol when refueling .Spilled petrol or petrol vapor may ignite.
The machine is best suited to the compaction of bituminous and granular materials e.g. granular soils such as silt and clay are best compacted using the impact force produced by a vibrating rammer. Where possible the site should be graded and leveled before commencing compaction. For more information of starting and correct operating procedures o the motor, refer to the motor operation manual supplied with the unit.
Model 350WSB & 350WSB With Stand Parts List TABLE 2.ENGINE CHECK ( For details, see separate engine manual) ITEM Hours of Operation Leakage of oil fuel Every8 hours ( every day) Tightness of fastening Threads Every8 hours ( every day) Engine oil check and replenishment Every8 hours ( every day) (Replenish to specified Max.
CAUTION: NEVER attempt to check the V-belt with the engine running. Severe injury can occur if your hand gets caught between the V-belt and the clutch. Always use safety gloves. Checking and Replacing the V-belt and Clutch After 200 hours of operation, remove the upper belt cover to check the V-belt tension (Figure 2).Tension is proper if the belt bends about 10mm when depressed strongly with finger between shafts.
TRANSPORTATION 1.Always shut off engine when transporting machine. 2.Make sure lifting device has enough capacity to hold machine ( see identification plate on machine for weight). 3.Use central lifting point (a) (c) (as optional) when lifting machine. 4.Trolley wheel (b) as optional is used for short distance transportation. TROUBLE SHOOTING SYMPTOM POSSIBLE CAUSES SOLUTION Travel Speed too low, Engine speed too low? Set engine speed to correct RPM.
KPC160W PLATE COMPACTOR DIAGRAM 8
KPC160W PARTS LIST ITEM NO. PART NO.
ITEM NO. PART NO.
KPC160W PLATE COMPACTOR DIAGRAM 11
KPC160W PLATE COMPACTOR DIAGRAM 12 WARRANTY These products are covered by warranty for a period of six(6) months from the date of purchase against defects in material or workmanship provided that: The product concerned has been operated and maintained in accordance with the operating instructions. Has not been damaged by accident, misuse or abuse. Has not been tampered with or repaired by any unauthorized person.
MAINTENANCE RECORDS PREVENTATIVE MAINTENANCE AND ROUTINE SERVICE PLAN This plate compactor has been assembled with care and will provide years of service. Preventative maintenance and routine service are essential to the long life of our plate compactor. After reading through this manual thoroughly, you will find that you can do some of the regular maintenance yourself. However, when in need of parts or major service, be sure to see your dealer.
