User Manual
Model 350WSB & 350WSB With Stand Parts List
5
TABLE 2.ENGINE CHECK
( For details, see separate engine manual)
ITEM Hours of Operation
Leakage of oil fuel Every8 hours ( every day)
Tightness of fastening reads Every8 hours ( every day)
Engine oil check and replenishment Every8 hours ( every day)
(Replenish to specied Max. Level)
Engine oil replenishment At rst 20 hours, then every 100 hours
Air cleaner cleaning Every 50 hours
CAUTION
ese inspection intervals are for operation under normal conditions. Adjust your inspection intervals based on the
number hours plate compactor is in use, and particular working conditions.
CAUTION
Fuel piping and connections should be replaced every 2 years.
Daily Service
Check for leakage of fuel or oil.
Remove soil and clean the bottom of compaction plate.
Check for loose screws including tightness. See Table 3 below ( Tightening torque), for retightening.
TABLE 3
TIGHTENING TORQUE (in.kg/cm) Diameter
Material 6mm 8mm 10mm 12mm 14mm 16mm
4T 70 150 300 500 750 1100
6-8T 100 250 500 800 1300 2000
11T 150 400 800 1200 2000 2900
Changing Vibrator Oil
When changing the vibrator oil, remove the drain plug located at the bottom-right of the vibrator, and simply tip the
compactor to drain the oil. Note that the oil will drain more easily while it is hot. Replace the oil with 200ML of 10W-30
motor oil.
Air Filter
1.e air lter element should be cheaned because a clogged air cleaner can cause poor engine starting, lack of power
and shorten engine life substantially.
2.To clean or replace air lter loosen the wing nut on the air lter housing (Figure 1), remove the cover and take out air
lter cartridge. If only cheaning of the air lter is desired blow through the air lter cartridge from the inside, moving a
jet of dry compressed air up and down until all dust is removed.