User's Manual

Output Power 1% 100W
CH3
UK 230VAC/50Hz, 160W nominal
1/8” Line Level or Bluetooth Device
4 Ohm load
CH 1 and 2 Mic XLR Balanced, Line level 1/4" Un-balanced
-56dB Residual Noise, all level controls 0% (minimum)
-48dB Nominal System Noise, all level controls at 50%
+70dB Mic to Speaker Output (CH 1 & 2)
+56dB Line to Speaker Output (CH 1 & 2)
+42dB AUX IN to Speaker Output
Channel EQ (high, low)
Subwoofer Out Line Out 20Hz-150Hz.
Phantom Power
+15V Mic inputs (Ch 1 & 2)
USA/Canada 120VAC/60Hz, 160W nominal
Europe 230VAC/50Hz, 160W nominal
Australia 240VAC/50Hz, 160W nominal
Japan 100VAC/50-60Hz, 160W nominal
Speakers
Horn 1” Neodymium Compression Driver
Four 4½" 50W 4 Ohm each
Power Capacity
100W RMS
60HZ-20kHz
Full range (subwoofer jack not used)
150HZ-20kHz
Crossover Active (1/4" mono plug in subwoofer jack)
Nominal Impedance 4 Ohms Not designed for external speakers
mm/kg 175 W x 760 H x 200 D / 11.2 kg
Inches/Pounds 7 W x 30 H x 8 D / 24.5 lbs
Hum & Noise
Frequency Response
Dimensions & Weight
DAWN100BT Specifications
4kHz and above , 800Hz and below.
Power Requirements
SYSTEM LINK (IN and OUT)
Both jacks accept a balanced input and sends a pre-master volume output mix of
channels. Recommended use: Linking two DAWN100BT’s together.
System Gain
(Measurements made at
1kHz)
Frequency Response 20HZ-20kHz
Actual response is tailored to speaker cabinet for
accurate acoustical response.
Accepted Inputs
Bluetooth Module Features
Bluetooth 3.0+EDR compliant. Typical +2dBm Class 2
output power. Audio DAC:94dB SNR.A2DP profile support.