PW2X6BT & PW3X6BT Owner’s Manual Congratulations on the purchase of your Powerwerks Tower Speaker! These models draw on decades of electronic design and manufacturing experience at Powerwerks. This model was built from the ground up to offer useful features, high signal-to-noise ratio, and reliable performance. Inside this manual, you’ll find valuable information about your product’s controls and specifications. Being familiar with its features will help you effectively use your Powerwerks product.
IMPORTANT SAFETY INSTRUCTIONS Danger Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably to noise induced hearing loss but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. 1. 2. 3. The U.S. Government's Occupational Safety and Health Administration (OSHA) has specified the following permissible noise level exposures: 4. DURATION PER DAY (HOURS) 8 6 SOUND LEVEL (dB) 90 93 6. 7.
IMPORTANT SAFETY INSTRUCTIONS FRENCH 1. Danger L‘exposition a des niveaux eleves de bruit peut provoquer une perte permanente de l’audition, Chaque organisme humain reagit differemment quant a la perte de l’audition, mais quasiment tout le monde subit une diminution de I’acuite auditive lors d’une exposition suffisamment longue au bruit intense.
4 4 3 3 5 5 2 6 7 11 1 8 9 14 BLUETOOTH PAIRING INSTRUCTIONS: To connect your Bluetooth device to the 3RZHUZHUNV %OXHWRRWK UHFHLYHU IRU WKH ¿UVW time, navigate to the Bluetooth settings menu on you Bluetooth enabled device. Ensure that Bluetooth is enabled and your Powerwerks product is powered on. Perform a scan for available devices. Select and pair to the Powerwerks product in the list of available devices. Enter 0000 for the passcode if prompted.
CONTROLS & FUNCTIONS OVERVIEW 1. MIC INPUTS: Connect dynamic and condenser microphones here. These inputs are designed for low-impedance mics and equipment that has a mic-level, balanced output. 15-volt phantom power is supplied to all MIC Inputs. 2. LINE INPUTS: These ¼-inch inputs may be used to connect high-impedance microphones, keyboards, drum modules and other audio devices. 3. LOW: Adjusts bass frequencies (@100Hz) per channel. Turn clockwise to boost, counter-clockwise to cut. 4.
PW2X6BT SpeciĮcaƟŽns Peak Output Power 200W 4 ohm load CH1 and CH2 Mic XLR Balanced, Line Level 1/4" Un-balanced Accepted Inputs Ch3 1/8" Line Level or Bluetooth Device -56dB Residual Noise, all level controls 0% (mimimum) Hum & Noise -48dB Nominal System Noise, all level controls at 50% System Gain/Speaker Output +70dB Mic to Speaker Output (CH 1 & CH2) (Measurement made at 1kHz) +56dB Line to Speaker Output (CH1 & CH2) +42dB Aux In to Speaker Output Channel EQ (high, low) 4kHz and above, 800Hz and below
3 2 1 AUX MIC LINE MIC LINE Bluetooth Receiver Phantom Power 15V Phantom Power 15V GAIN GAIN low low low high high high Aux Input Disables Bluetooth volume volume volume CHANNELS OUT IN POWERLINK MASTER LINKING BUS MASTER SUB LP Filter Conditioning Hi Pass Filter (HPF) HORN POWER AMP + _ + _ + _ SUBWOOFER OUT Inserting 1/4" mono (tip/sleeve) SHIELDED instrument cable into subwoofer out jack activates HPF.
17 18 4 4 3 3 5 5 2 6 7 1 11 10 8 9 14 12 12 15 16 13 BLUETOOTH PAIRING INSTRUCTIONS: To connect your Bluetooth device to the 3RZHUZHUNV %OXHWRRWK UHFHLYHU IRU WKH ¿UVW time, navigate to the Bluetooth settings menu on you Bluetooth enabled device. Ensure that Bluetooth is enabled and your Powerwerks product is powered on. Perform a scan for available devices. Select and pair to the Powerwerks product in the list of available devices. Enter 0000 for the passcode if prompted.
CONTROLS & FUNCTIONS OVERVIEW 1. MIC INPUTS: Connect dynamic and condenser microphones here. These inputs are designed for low-impedance mics and equipment that has a mic-level, balanced output. 15-volt phantom power is supplied to all MIC Inputs. 2. LINE INPUTS: These ¼-inch inputs may be used to connect high-impedance microphones, keyboards, drum modules, and other audio devices. 3. LOW: Adjusts bass frequencies (@100Hz) per channel. Turn clockwise to boost, counter-clockwise to cut. 4.
PW3X6BT SpeciĮcaƟŽns Peak Output Power 300W 4 ohm load CH1 and CH2 Mic XLR Balanced, Line Level 1/4" Un-balanced Accepted Inputs Ch3 1/8" Line Level or Bluetooth Device -46dB Residual Noise, all level controls 0% (mimimum) Hum & Noise -37dB Nominal System Noise, all level controls at 50% System Gain/Speaker Output +49dB Mic to Speaker Output (CH 1 & CH2) (Measurement made at 1kHz) +35dB Line to Speaker Output (CH1 & CH2) +25dB Aux In to Speaker Output Channel EQ (high, low) 4kHz and above, 800Hz and below
3 2 1 AUX MIC LINE MIC LINE Bluetooth Receiver Phantom Power 15V Phantom Power 15V GAIN Effect Select GAIN high Aux Input Disables Bluetooth high volume Effect Level 2 volume low low volume Effect Level 1 high Digital Effects low CHANNELS BALANCED MONITOR OUT OUT IN LINKING BUS MONITOR LEVEL MASTER POWERLINK MASTER SUB LP Filter Conditioning Hi Pass Filter (HPF) POWER AMP1 3kHz 3kHz 3kHz Crossover + _ + _ + _ + _ 8 ohm 8 ohm 8 ohm 8 ohm SUBWOOFER OUT Inserti
This warranty is for Powerwerks products only. Any service claims resulting from other brands used in conjunction with Powerwerks products will not be allowed or honored. This warranty will be void if: A. The unit has been altered or modified. B. The serial number has been removed or defaced. C. The unit has been operated improperly. This warranty is subject to the following conditions and exclusions: Defects caused by wear and tear, misuse or neglect are not covered by this warranty.
EC Declaration of Conformity We: Kustom Musical Amplification INC. 3015 Kustom Drive Hebron, Ky 41048 Tel: 1-859-817-7100 Fax: 1-859-817-7150 Declare that the product Product name: Powerwerks Product model number: PW2X6BT & PW3X6BT to which this declaration relates is in conformity with the following standards; EN55013: 2001/+A1: 2003+A2: 2006 Limits and methods of measurement of radio disturbance characteristics of broadcast receivers and associated equipment.
PW2X6BT & PW3X6BT OWNER’S MANUAL www.powerwerks.
