User Manual

Peak Output Power 300W 4 ohm load
CH1 and CH2 Mic XLR Balanced, Line Level 1/4" Un-balanced
Ch3 1/8" Line Level or Bluetooth Device
-46dB Residual Noise, all level controls 0% (mimimum)
-37dB Nominal System Noise, all level controls at 50%
+49dB Mic to Speaker Output (CH 1 & CH2)
+35dB Line to Speaker Output (CH1 & CH2)
+25dB Aux In to Speaker Output
Channel EQ (high, low)
Subwoofer Out
Line Out 20 Hz-150Hz
Monitor Out
Line Out Balanced TRS Output with grounded sleeve
Phantom Power
+15V Mic inputs (CH1 & CH2)
USA/Canada 120VAC/60Hz, 300W nominal
Europe 230VAC/50Hz, 300W nominal
UK 230VAC/50Hz, 300W nominal
Australia 240VAC/50Hz, 300W nominal
Japan 100VAC/50-60Hz, 300W nominal
Speakers
Three 6" 8 ohm each
Horn
Frequency Response
65Hz-20KHz Full range (subwoofer jack not used)
150Hz-20KHz Crossover ĐƟǀe (1/4" mono plug in subwoofer jack)
Nominal Impedance 4 ohm x 2
Not designed for external speakers
Dimensions & Weight mm/kg
240mm D x 205mm W x 730mm H / 13.15 kg
Inches/Pounds
9.5" D x 8" W x 28.75" H / 29 lbs
PW3X6BT SpeciĮcaƟŽns
Hum & Noise
Accepted Inputs
1" Neodymium Compression Driver
Bluetooth Module Features
Bluetooth 3.0+EDR compliant. Typical +2dBm Class 2 output
power. Audio DAC:94dB SNR. A2DP proĮle support
System Gain/Speaker Output
(Measurement made at 1kHz)
4kHz and above, 800Hz and below
Powerlink (IN and OUT)
Both jacks accept a balanced input and sends a pre-master volume output mix of
channels. Recommended use: Linking two Powerwerks models
Power Requirements