User's Manual

 
3.4
3.3 RADAR INSTALLATION
1. The FalconHR is shipped with the handle (corded or
cordless) attached. With the handle attached, the user
can operate the unit in the handheld or dash mounted
mode. In the handheld configuration, the radar operates
only in the stationary mode when the unit is removed
from the mount. In this situation, the transmitter is only
active when the trigger is pulled.
2. For dash mounting, the unit can operate with the handle
attached placed in the dash mount, or with the pod
attached and mounted on the pod bracket. When the
unit with a handle is placed in the dash mount, the
trigger is inoperable and the remote control is used to
control the unit. To attach the pod, remove the handle
by pressing the blue release button (latch) on the
bottom of the indicator and sliding the handle
backwards. Locate the dash bracket and mounting pod.
Fasten the mounting pod to the dash bracket, and then
slide the FalconHR onto the pod by placing it in front
of the pod and sliding backwards. The mounting pod
may be turned 90° on the mount and the FalconHR slid
onto it from the side.
3. Position the radar and mount in a suitable location on
the dash within view of the driver and in a safety zone
during airbag deployment. Normally this will be to the
left or right of the steering wheel as space permits.
4. Connect the FalconHR’s power cable to the proper
power source. See Section 3.2.1.