User's Manual

   
6.9
6.6 MINIMUM PATROL SPEED SET
1. When the speedometer input feature is not used, the
FalconHR allows the operator to set a minimum patrol
speed of 10, 20, 30 or 40 mph (16, 32, 48 or 64 km/h).
2. To activate this feature, place the unit in the moving
mode and press the PAT SEL switch one (1) time. The
unit will display “P” in the Patrol window and the last
selected minimum patrol speed will be displayed.
Default is the lowest value (10 mph/16 km/h).
To change the value, immediately press the remote’s
LOCK/REL switch. Repeat until the desired value appears.
Once the desired minimum value is selected, the unit will
time out in 2 seconds and the last displayed value will be
accepted as the new minimum patrol speed.
6.7 MOVING MODE TEST
Verification of speed readings between the patrol vehicle's
speedometer and the FalconHR’s PATROL speed display
is another accuracy test that can be performed. These
readings should be the same, or within reasonable limits,
allowing for minor speedometer error.
Speedometer checks should be done on a daily basis. If a
discrepancy is found, the radar unit should be removed
from service until the error can be corrected.