User's Manual


7.9
7.4 MOVING MODE—OPPOSITE DIRECTION
1. Place the FalconHR in the moving mode by pressing
the Mode switch, if needed, so that both the TARGET
and PATROL windows’ indicators are lit. If
necessary, select Opposite Direction mode by pressing
SAME/OPP switch on the remote control (the opposite
road graphic indicator will be lit).
2. If the speedometer input feature is not used, check the
setting of the minimum patrol speed. To display the
existing patrol minimum setting, press the PAT SEL
switch one (1) time. To change the patrol minimum
setting refer to Sec. 6.6 (MINIMUM PATROL SPEED
SET).
3. While driving, observe traffic and complete a tracking
history as described in Section 7.2.1 Step 4 and verify
the radar’s patrol speed reading with the patrol
vehicle’s speedometer. When all elements agree,
enforcement action may be taken.
NOTE: If an incorrect Patrol speed is obtained, the
operator can go in and out of HOLD
quickly. This will clear all previous speeds,
and a new patrol speed search will be
initiated. See Sec. 7.7
7.4.1 HOLD MODE
The FalconHR may be placed in the Hold mode (non-
transmit) by pressing HOLD on the remote control. The
HOLD indicator on the rear panel of the FalconHR will
light and the displays will blank (locked speeds will
remain). To return to normal radar operation, press
HOLD again.