User's Manual

"   
A.3
To manually set the time and date, the operator needs to
enter the maintenance menu screens on power up. To enter
the maintenance menu mode, power the unit off, then press
and hold the POWER switch until the power-on sequence
stops at the 'Snc' display. Pressing the TEST switch
advances the display to the next maintenance screen.
To set the time in the FalconHR, advance the maintenance
screen to the 'CLO' display. The current hour will be
flashing. To adjust the hour setting, use the down (AUD)
or up (RNG) switches. Press the MODE switch to adjust
the minute setting. While the minute display is flashing,
use the down (AUD) or up (RNG) switch.
Press the TEST switch to advance to the 'CAL' screen. The
current month will be flashing. To adjust the month
setting, use the down (AUD) or up (RNG) switches. Press
the MODE switch to adjust the date setting. While the date
display is flashing, use the down (AUD) or up (RNG)
switch.
Press the TEST switch to advance to the 'Yr' screen. The
current year will be flashing. To adjust the year setting, use
the down (AUD) or up (RNG) switch.
Pressing the TEST switch while in the 'Yr' maintenance
screen will advance to the DataLogger memory utilized
screen 'UtL' if the FalconHR has DataLogger feature. If the
FalconHR does not have the DataLogger feature, pressing
TEST while in the Yr screen will advance the unit to its
normal operating mode.
While in the 'UtL' screen, the percentage of memory
already used for the DataLogger will be displayed. For
example, if UtL and 20 are displayed, 20% of the unit's
nonvolatile memory is currently storing data, and 80% is
remaining and is available to store data.