User Manual

After successfully log in , click “quick setting” to make settings of “user setting”,”Internet setting”,
“Wireless setting”, then click “Finish”
2.3.2 Establish the network connection through USB
This function is only for PC, process shows as below:
PC drive installation
Connect the device with PC via USB cable, power on the device. When the screen lit up, select “Install
Marvell DIAG USB Device”to star the drive
2.3.3 Through the blend mode to establish network connection
Open the device, use the USB cable to connect MiFi with a computer, other supporting Wi-Fi equipments
can connect with MiFi via Wi-Fi at the same time, Surf the Internet at the same time, as shown in the figure
below.