Installation Guide

ManualsBrandsKuzco Lighting ManualsLightingMina 36" Tall LED Mini Pendant

19054 28th Avenue Surrey, BC Canada V3Z 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

W: kuzcolighting.com

20160812

2c.

2a.

1a.

1b.

1e.

1c.

1d.

INSTALLATION SHEET

401216

Ceiling LED Pendant

START FROM HERE

•

Make sure power is completely off at the fuse box.

•

Have your fixture installed by a qualified licensed electrician

•

Prepare everything in a clear area.

•

Wear gloves at all times during this installation.

•

Read instructions carefully before you start assembly.

•

Keep this instruction sheet for future reference.

Technical Support: 1-877-452-6858

Please Note:

• All Kuzco LED fixtures come with pre-wired LED module(s).

• Unless instructed to do so, please do not touch any part of the LED module(s) as any

unnecessary contact with the module could cause permanent damage.

• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.

You are now ready to mount the canopy (2a) to the

mounting plate (1c). First connect all wires (1b) correctly L

live wire (black to black) N neutral wire (white to white) and

G ground to ground with provided marettes (1b) from the

hardware package. Align the threaded screws (1d) hanging

downward from the mounting plate to the holes inside the

canopy (2a). Push the canopy up towards the ceiling so the

two screws clears through the hole in the canopy (2a). You

can now screw on the decorative nuts (2c) onto the

threaded studs (1d) pointing through the canopy and

securely connect the canopy to the mounting plate (1c).

Remove the fixture from its original packaging. Remove the

mounting plate (1c) from within the canopy (2a) by remov-

ing the two decorative nuts (2c). Secure the mounting plate

(1c) to the junction box (1a) with the screws (1e) provided

in the hardware package.

Before you mount the canopy to the mounting plate select

the desired length you wish the pendant to hang.

To shorten or lengthen the fixture push up on the canopy

nipples (2b) and push/pull the cable, release to secure.

You have now completed the installation of your fixture,

enjoy.

2b.