Installation Guide

INSTALLATION SHEET
402401CH-LED
3.
2.
1.
Remove the fixture from its original packaging. Remove
the canopy mounting plate from within the canopy and
attach it to the electrical junction box on the ceiling using
the two screws provided in the hardware package.
Select the desired length you would like the fixture to
hang down from the ceiling (72” maximum). (2a)To set
the fixture hanging height, simply push in the sleeve at
the canopy where the wire comes out from. Once the
sleeve is pushed in you can push the wire up to shorten,
or pull the wire down to lengthen. When you have
selected your desired length, just release the sleeve and
the wire will be held tightly in place.
Attach the canopy to the mounting plate, which is
attached to the electrical junction box on the ceiling. First
attach all wiring with the provided marrets (white to white
“N”, black to black “L”, ground to ground “G”). Align the
two holes from the canopy to the two screws pointing
down from the mounting plate. Push the screws through
the canopy plate so they are poking through, once this is
complete you can screw on the decorative nuts until tight.
1.
2.
3.
2a.
START FROM HERE
▪
▪
▪
▪
▪
▪
Make sure power is completely off at the fuse box.
Have your fixture installed by a qualified licensed
electrician
Prepare everything in clear area.
Wear gloves at all times during this installation.
Read instructions carefully before you start assembly.
Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
19054 28th Avenue, Surrey, BC, Canada V3Z 6M3
T: 604-538-7162 TF: 1-855-85-KUZCO F: 604-538-7196
W: kuzcolighting.com
20140630
4.
Install acrylic diffuser(s) (4) by screwing into housing.(4A.)
(DO NOT OVER TIGHTEN)
You have now completed the installation of your fixture,
please enjoy.
5.
4a.
4.
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the
LED module(s) as any unnecessary contact with the module
could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) dimmer is
required.