Installation Guide

INSTALLATION SHEET
601002-LED
LED Lamp Wall Sconce
1.
2.
3.
4.
5.
START FROM HERE
▪
▪
▪
▪
▪
▪
Make sure power is completely off at the fuse box.
Have your fixture installed by a qualified licensed
electrician
Prepare everything in clear area.
Wear gloves at all times during this installation.
Read instructions carefully before you start assembly.
Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20150601
Please Note:
• All Kuzco LED fixtures come with pre-wired LED
module(s).
• Unless instructed to do so, please do not touch any part
of the LED module(s) as any unnecessary contact with the
module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) dimmer is
required.
Remove the xture from its original packaging. Remove
the canopy mounting plate (1a.) from within the canopy and
attach it to the electrical junction box, using the two
screws provided in the hardware package.
Push the canopy mounting screw (1b.) through the center hole
of the metal cover plate, then (2a) feed the electrical
wires, from inside the electrical box, through the second
hole in the metal cover plate. (2b) Push the canopy
mounting screw through the center hole in the back of the
canopy back plate until it is poking through, then feed
the electrical wires through the second hole in the canopy
back plate. Once this is complete you can (2c) screw on
the mounting nut until tight, and (2e) secure the canopy
back plate using the screws provided in the hardware
package.
1a.
2b.
1a.
1b.
1b.
2c.
2e.
Attach the canopy to the canopy back plate, which is
attached to the electrical junction box. First attach all
wiring with the provided marrets (white to white “N”, black
to black “L”, ground to ground “G”). Align the holes on the
sides of the canopy to the holes on the canopy back plate.
Once aligned, screw in the four screws provided to secure
the canopy to the back plate.
Gently slide the glass cover into the (4a) glass holder
bracket at the end of the canopy. Then, (4b) install the
metal end plate, the (4c) glass holder bracket, and (4d)
the decorative nut to secure the glass cover to the canopy
(do not over tighten).
You have now completed the installation of your xture,
please enjoy.
4b.
4c.
4d.
3.
4a.
4.