Installation Guide

INSTALLATION SHEET
601464/65CH-LED
Multi LED Lamp Vanity
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20140912
START FROM HERE
▪
▪
▪
▪
▪
▪
Make sure power is completely off at the fuse box.
Have your fixture installed by a qualified licensed
electrician
Prepare everything in clear area.
Wear gloves at all times during this installation.
Read instructions carefully before you start assembly.
Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
1.
Remove the fixture from its original packaging. Remove
the canopy mounting plate from within the canopy and
attach it to the electrical junction box, and wall, using the
screws provided in the hardware package.
2.
Attach the canopy to the mounting plate, which is attached
to the electrical junction box on the wall. First attach all
wiring with the provided marrets (white to white “N”, black
to black “L”, ground to ground “G”). Push the canopy onto
the mounting plate, then insert the screw(s) into the
hole(s) on the top of the canopy, once inserted, screw in
the screw(s) provided to secure the fixture to the wall.
3.
You have now completed the installation of your fixture,
please enjoy.
1.
2.
Please Note:
• All Kuzco LED fixtures come with pre-wired LED
module(s).
• Unless instructed to do so, please do not touch any part
of the LED module(s) as any unnecessary contact with the
module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) dimmer is
required.