Installation Guide

19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20150407
Remove the fixture from its original packaging. Remove the mounting
plate (1c) from within the canopy (3b) and attach it to the electrical
junction box (1a), and wall, using the screws (2a) provided in the
hardware package. Mount the plate (1c) to the wall with screws (2b),
make sure to reinforce the wood behind the drywall.
Attach the canopy (3b) to the mounting plate (1c), which is attached to
the electrical junction box on the wall. First attach all wiring (1b) with
the provided marrets (white to white “N”, black to black “L”, ground to
ground “G”). Push the canopy (3b) onto the mounting plate (1c), then
insert the four screws (3a) into the hole(s) on the top and bottom of the
canopy.
You have now completed the installation of your fixture, enjoy.
INSTALLATION SHEET
701313
Rectangular LED Vanity Lamp
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
CAUTION: CAUTION: HEAVEY FIXTURE, THE JUNCTION BOX
NEEDS TO BE REINFORCED BEFORE INSTALLATION.
1.
2.
3.
1c.
1a.
2b.
1b.
2a.
3b.
3a.