Installation Guide

INSTALLATION SHEET
AT7924
LED Lamp Wall Sconce
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support:
1-855-855-8926
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
You have now completed the installation of your fixture, please
enjoy.
Attach the canopy (2a) to the mounting plate (1c) on the wall.
First attach all wiring with the provided marettes (1b) (white to
white “N”, black to black “L”, ground to ground “G”). Now attach
the canopy (2a) to the mounting plate (1c) `(see illustration_01)
by tightening the two set screws (2b) using the allen key provided
in the hardware package.
1.
2.
3.
Remove the fixture from its original packaging. Remove the
mounting plate (1c) from within the canopy (2a) by loosening the
two set screws (2b). Attach the mounting plate (1c) to the single
gang box (1a), using the two screws (1d) provided in the
hardware package.
NOTE: there are two options for connecting the base of your
fixture. The first using a narrow back plate and the second using
a wide back plate. Use the instructions on this page to secure a
narrow back plate to a switch box. See instructions on back side
for a larg box.
5.
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20191003
illustration_01
ETL lable
3b. 3c.
3d.
3b.
4a.
3d.
3e.
3e.
3f.
illustration_03
ETL lable
ETL lable
illustration_02
Remove the large canopy (3c) from the back side of the fixture by
removing all 4 screws (3b) (Illustration_02). Next pull off this
canopy (3c). Do not loose this canopy as it contains the ETL
number. Connect the small canopy (4a) to the back side of the
fixture (3f) using all four screws (3b) see illustration_03
Important, secure the ground lead wire (3d) to one of the screws.
1c.
1d.
1b.
1a.
2a.
2b.
4.
*FOR OUTDOOR OPTION ONLY*
To prevent moisture from entering the outlet box and causing a
short, seal around the top and side perimeter between the fixture
and the wall surface with weather resistant caulking (see Outdoor
Option). The space at bottom should be left un-caulked to prevent
moisture build-up.
caulking
FOR OUTDOOR OPTION
Single gang box for AT79 option
(SOLD SEPARATELY)