Installation Guide

INSTALLATION SHEET
AT7935
LED Lamp Wall Sconce
START FROM HERE
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
1c.
2a.
1b.
1a.
1d.
2b.
2c.
2d.
Single gang box for AT79 option
(SOLD SEPARATELY)
caulking
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20190926
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all time during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
3.
*FOR OUTDOOR OPTION ONLY*
To prevent moisture from entering the outlet box and
causing a short, seal around the top and side perimeter
between the fixture and the wall surface with weather
resistant caulking (see Outdoor Option). The space at
bottom should be left un-caulked to prevent moisture
build-up.
You have now completed the installation of your fixture,
please enjoy.
Attach the anchor plate (2a) to the mounting plate (1c),
which is attached to the electrical junction box (1a) on the
wall. First attach all wiring with the provided marettes(1b)
(white to white “N”, black to black “L”, ground to ground
“G”). Now connect the anchor plate (2a) to the mounting
plate (1c) using the screws (2b). Now push the canopy
backplate (2c) onto the anchor plate (2a). Using the set
screws (2d) thread the canopy backplate to the anchor
plate turning clockwise until secure.
1.
2.
4.
Remove the fixture from its original packaging. Remove
the mounting plate (1c) and anchor plate (2a) from within
the canopy (2c) by loosening the two set screws (2d).
Attach
the mounting plate (1c) to the electrical junction
box (1a), using the two screws (1d) provided in the
hardware package.
NOTE: there are two options for connecting the base of your
fixture. The first using a narrow back plate and the second
using a large back plate. Use the instructions on this page
to secure the large back plate to a large J box.
FOR OUTDOOR OPTION