Installation Guide

V+
V-
DC
Driver
Illustration 02
+
-
L
N
White
Black
Low Voltage
120V
Black
White
2d.
1a.
1b.
1c.
1d.
2a.
2c.
2e.
2b.
2f.
2g.
Select the hanging height of the fixture by adding or removing
extension rods (2e) from the hardware package. Determine how
much wire (2f) is needed from the hub (3a) to the DC driver in the
canopy (2a). Depending on the length of the extension rods used,
provide 7” of extra wire for connection up to the DC Driver
(Shorten the wires if required)(DO NOT CUT WIRE SHORTER
THAN 17” when using 6”+ 4” rods for the minimum hanging
height). Connect each rod (2e), starting from the hub going
clockwise while pushing the wires (2f) through each rod until you
reach the swivel connector. Before connecting the wires (2f) to the
driver, make sure to insert the canopy cover (2d) through the rods
(2e). Once the rods are fully connected and wires are pulled into
the canopy, connect the wires to the DC driver by using the wire
connector (2g) provided. Black to black and white to white (See
Illustration 02 and refer to the diagram on the driver). Lastly,
attach the canopy cover to the canopy by turning clockwise.
Extension rods included (3 x 12”),(1 x 6”), and (1 x 4”).
Remove the fixture from its original packaging. Secure the
mounting plate (1c) to the junction box (1a) with the screws (1d)
provided in the hardware package. Remove the driver cover (2d)
and the canopy end cover (2h) from the canopy by turning counter
clockwise. Connect all wires from the driver to the wires from the
junction box correctly G ground to ground, N neutral wire (white to
white), L live wire (black to black) with provided wire connectors
(1b). Align the holes in the canopy (2a) to the threaded holes in
the mounting plate (1c). Push the canopy up towards the ceiling.
Use the screws (2b) to secure the canopy onto the mounting plate.
2h.
You have now completed the installation of your fixture,
enjoy.
INSTALLATION SHEET
CH14232
LED Chandelier
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
1.
3.
Please Note:
• For dimming, an ELV (Electronic Low Voltage) or a TRIAC type of dimmer is required.
2.
Next, install the LED spokes (3b) to the center of the fixture hub
(3a) by simply pushing in the spokes.
4.
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20181207
3a.
3b.