Installation Guide

INSTALLING FROM STUD WALLS
With the switch box secured to the wall connect the fixture (3c).
First, attach all wiring with the provided marettes (3b)
(white to white “N”, black to black “L”, ground to ground “G’).
You can now install the fixture (3c) onto the switch box (3a)
Thread the two screws (3d) (right and left) down onto the
switch box (1a) using the allen key provided in the hardware
package.
3b.3a. 3d.3c.
1e.1f.
1a.
1d.
2a.
2c.
1c.
1b.
INSTALLATION SHEET
LED Step Light
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
Please Note:
• All Kuzco LED fixture comes with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
•
NOTE: the concrete box and metal box is sold separately, see our online
store for a correct match.
ER7110
1.
(Sold Separately)
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20200303
INSTALLING THE CONCRETE BOX
1. The concrete box (1a) is suitable for installation in outdoor
wall mount applications including concrete pour. IMPORTANT
NOTE: For proper waterproof seal, ensure that Face A of the
concrete box (1a) is flush against the finished wall (Illustration
1) such that the lip of the concrete box (1a) is protruding at
least 2mm from the finished wall (Illustration 2)
2. Install the concrete box (1a) in opening using brackets (1e) by
attaching them to the mounting surface using the appropriate
screws (not provided).
3. Provide electrical wiring to the concrete box (1a) (according to
local electrical code) by removing the conduit plug (1f) and
using conduit with appropriate fittings (not provided). Ensure
that all unused conduit openings are adequately closed/sealed
with the conduit plug (1f). Pull supply wires into the concrete
box (1a).
4. If ready to install fixture, proceed to step 5, otherwise replace
cover plate (1c) to protect supply wires inside concrete box (1a)
INSTALLING THE FIXTURE
5. Remove cover plate (1c) from the concrete box (1a) by
removing screws (1b). Attach all wiring with the wire nuts (1d)
provided in the hardware package (white to white “N”, black to
black “L” and ground to ground
“G”).
6. Verify that the housing gasket is free of debris to ensure proper
seal. Align the fixture body (2a) to the concrete box (1a) and
use the screws (2c) and Allen Key provided in the hardware
7. You have now completed the installation of your fixture.
Illustration 1
Illustration 2