Installation Guide

ManualsBrandsKuzco Lighting ManualsLightingWarner 12" Tall LED Outdoor Wall Sconce - Left Facing Shade

2b.

1c.

1a.

2a.

1d.

1b.

19054 28th Avenue Surrey, BC Canada V3Z 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

W: kuzcolighting.com

20160527

INSTALLATION SHEET

EW13212

LED Exterior Wall Sconce

START FROM HERE

•

Make sure power is completely off at the fuse box.

•

Have your fixture installed by a qualified licensed electrician

•

Prepare everything in a clear area.

•

Wear gloves at all times during this installation.

•

Read instructions carefully before you start assembly.

•

Keep this instruction sheet for future reference.

Technical Support: 1-855-855-8926

Please Note:

• All Kuzco LED fixtures come with pre-wired LED module(s).

• Unless instructed to do so, please do not touch any part of the LED module(s) as any

unnecessary contact with the module could cause permanent damage.

• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.

Remove the fixture from its original packaging. Remove the

mounting plate (1c) from within the canopy backplate (2b)

by unthreading two set screws (2a). Attach the mounting

plate(1c) to the electrical junction box (1a), using screws

(1d) provided in the hardware package.

Attach the canopy to the mounting plate, which is attached

to the electrical junction box on the wall. First connect all

wires correctly G ground to ground, N neutral wire (white to

white), L live wire (black to black) with provided marettes

(1b) from the hardware package. Now place the canopy

(2b) onto the mounting plate (1c) and secure the fixture by

using the two set screws (2a) provided.

You have now completed the installation of your fixture,

please enjoy.

To prevent moisture from entering the outlet box and

causing a short, seal around the top and side perimeter

between the fixture and the wall surface with weather

resistant caulking (Illustration 1). The space at bottom

should be left un-caulked to prevent moisture build-up.

Apply a small amount of weather resistant caulking around

the side perimeter between the cap nut and mounting

plate.

Illustration 1.

Caulking