Installation Guide

2b.
1c. 1a.
2a.
1d. 1b.
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20160527
You have now completed the installation of your fixture,
enjoy.
INSTALLATION SHEET
LED Exterior Wall Sconce
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) or a triac type of dimmer is required.
3.
4.
EW27140
1.
2.
Remove the fixture from its original packaging. Remove the
mounting plate (1c) from within the canopy (2a) by unthread-
ing the set screws (2b). Attach the mounting plate (1c) to the
electrical junction box (1a) using the screws (1d) provided in
the hardware package.
Attach the canopy to the mounting plate, which is attached
to the electrical junction box. First connect all wires correctly
G ground to ground, N neutral wire (white to white), L live
wire (black to black) with provided marettes (1b) from the
hardware package. Align the holes on the canopy (2a) to the
mounting plate (1c). Once aligned, Push the canopy (2a) to
the mounting plate (1c) and use the set screws (2b) to
secure the canopy.
Caulking
To prevent moisture from entering the outlet box and
causing a short, seal around the top and side perimeter
between the fixture and wall surface with weather resistant
caulking. The space at the bottom should be left un-caulked
to prevent moisture nuild-up. Apply a small amount of
weather resistant caulking aroung the side perimeter
between the cap nut and mounting plate