Installation Guide

1a.1b.1c.1d.2a.2b.
INSTALLATION SHEET
EW3207
LED Lamp Wall Sconce
START FROM HERE
Please Note:
• This Kuzco LED fixtures come with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage
• Use ELV (Electronic Low Voltage) type of dimmer for dimming application
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all time during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20190814
Remove the fixture from its original packaging. Remove the
mounting plate (1c) from within the canopy (2b) by removing the
two canopy screws (2a). Attach the mounting plate (1c) to the
electrical junction box (1a) using the two screws (1d) provided in
the hardware package.
Attach the canopy (2b) to the mounting plate (1c), which is
attached to the electrical junction box (1a) on the wall. First
attach all wiring with provided marettes (1b) (white to white “N”,
black to black “L”, ground to ground “G”). Now push the canopy
(2b) onto the mounting plate (1c) and install using the two
canopy screws (2a).
To prevent moisture from entering the outlet box and causing a
short, seal around the top and side perimeter between the fixture
and the wall surface with weather resistant caulking (see
illustration 3). The space at bottom should be left un-caulked to
prevent moisture build-up.
You have now completed the installation of your fixture, please
enjoy.
1.
2.
3.
4.
Illustration 3.
Caulking