Installation Guide

ManualsBrandsKuzco Lighting ManualsLightingByron 6" Tall LED Outdoor Wall Sconce - 5 Watts

2a. 2b. 2e.

2d.2c.

1a. 1c.2b.

2b.

1d.

Remove the fixture from its original packaging. First

remove the set screws (2d) from the side of the lamp cover

(2e) using the allen key provided. Now remove the

mounting plate (1c) from the backplate (2b) by removing

the round nuts (2c). Attach the mounting plate (1c) to the

electrical junction box (1a), using the screws (1d) provided.

in the hardware package.

Attach the backplate (2b) to the mounting plate (1c). First

attach all wiring (2a) with the provided marrets (white to

white “N”, black to black “L”, ground to ground “G”). Push

the fixture backplate (2b) onto the mounting plate (1c),

then thread the round nuts (2c) into the mounting plate

studs (1b). Next, place the lamp cover (2e) over the fixture

and secure with set screws (2d).

To prevent moisture from entering the outlet box and

causing a short, seal around the top and side perimeter

between the fixture and the wall surface with weather

resistant caulking (see illustration 3). The space at bottom

should be left un-caulked to prevent moisture build-up.

Apply a small amount of weather resistant caulking around

the side perimeter between the cap nut and mounting

plate.

You have now completed the installation of your fixture,

please enjoy.

Caulking Caulking

INSTALLATION SHEET

EW3506

LED Vanity Lamp

START FROM HERE

Please Note:

• This Kuzco LED fixtures come with pre-wired LED module(s)

• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary

contact with the module could cause permanent damage

• Use ELV (Electronic Low Voltage) type of dimmer for dimming application

• Make sure POWER is COMPLETELY OFF at the fuse box

• Have your fixture installed by a qualified licensed electrician

• Prepare everything in a clear area

• Wear gloves at all time during this installation

• Read instructions carefully before you start assembly

• Keep this installation sheet for future reference

Technical Support: 1-855-855-8926

19054 28th Avenue Surrey, BC Canada V3S 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

W: kuzcolighting.com

20190814

caulking

Illustration 3

Summary of content (1 pages)

PAGE 1
EW3506 LED Vanity Lamp INSTALLATION SHEET Please Note: • This Kuzco LED fixtures come with pre-wired LED module(s) • Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage • Use ELV (Electronic Low Voltage) type of dimmer for dimming application START FROM HERE • Make sure POWER is COMPLETELY OFF at the fuse box • Have your fixture installed by a qualified licensed electrician • Prepare everything in a clear area • Wear glove