Installation Guide

INSTALLATION SHEET
EW35204
LED Exterior Wall Sconce
START FROM HERE
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
1. Remove fixture from its original package.
2. Separate fixture body (2a) from mounting plate (1c) by
removing set screws with allen key (2f).
3. Attach mounting plate (1c) to electrical junction box (1a)
using junction box screws provided (1e) in hardware
package.
4. Make proper electrical connections (black to hot “L”,
white to neutral “N”, ground to “GND”) with wire nuts
(1b) provided in hardware package.
5. Attach fixture body (2a) to mounting plate (1c) with set
screws and allen key (2f).
caulking
Illustration 1
6. To prevent moisture from entering the electrical junction
box (1a) and causing a short, seal around the top and
side perimeter between the fixture and the wall surface
with weather resistant caulking (Illustration 1). The
space at the bottom should be left un-caulked to prevent
moisture build up.
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all times during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
Please Note:
• This Kuzco LED fixture comes with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage
20200107
1a. 1b. 1c.
1e.
2a. 2f.
PARTPRODUCT
ID
XHPP832-8
XHSSM5-14
1e.
2f.
LED Driver
XDR-LSC9-500-UNV-ND
XHAK-M5Allen Key