Installation Guide

1a.
1b.
1c.
1d.
1e.
2a.
2c. 2d.
2b.
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20170317
Remove the fixture from its original packaging. Remove the
mounting plate (1c) from within the canopy (2a) and cover
(2d) by loosening the screws (2b). Then remove the two
nuts (2c). Attach the mounting plate (1c) to the electrical
junction box (1a), using the two screws (1e) provided in
the hardware package.
Attach the canopy (2a) to the mounting plate (1c), which is
attached to the electrical junction box (1a) on the wall.
First attach all wiring with the provided marettes (1b)
(white to white “N”, black to black “L”, ground to ground
“G”). Now align the holes of the canopy (2a) towards the
threaded studs (1d) in the mounting plate (1c) and secure
the canopy (2a) with the two nuts (2c). Attach the cover
(2d) onto the canopy (2a) using the screw (2b).
You have now completed the installation of your fixture,
enjoy.
INSTALLATION SHEET
EW53916
LED Exterior Wall Sconce
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
1.
2.
4.
Illustration 1.
To prevent moisture from entering the outlet box and
causing a short, seal around the top and side perimeter
between the fixture and the wall surface with weather
resistant caulking (see illustration 1). The space at bottom
should be left un-caulked to prevent moisture build-up.
3.
Caulking