Installation Guide

INSTALLATION SHEET
EW60210
Exterior LED Lamp Wall Sconce
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
IMPORTANT: To prevent moisture from
entering the outlet box and causing a short,
seal around the top and side perimeter
between the fixture and the wall surface with
weather resistant caulking (see illustration
1). The space at bottom should be left
un-caulked to prevent moisture build-up.
illustration 1
1a.
caulking
Remove the fixture from its original packaging. Remove
the mounting plate (1c) from the fixture (2a) by
removing the screws (2b). Attach the mounting
plate (1c) to the electrical junction box (1a) using the
screws (1d) provided in the hardware package.
Connect all wiring with the provided marrettes (1b) (white
to white “N”, black to black “L”, ground to ground “G”).
Attach the fixture (2a) to the mounting plate (1c) and
secure with screws (2b).
You have now completed the installation of your fixture,
enjoy.
1.
2.
3.
1b. 1c. 1d. 2a.2b.
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20191206
19054 28th Avenue Surrey, BC Canada V3Z 6M3