Installation Guide

19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20160716
INSTALLATION SHEET
EW60308
Exterior LED Lamp Wall Sconce
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
2a.
1c.
1b.
1a.
1d.
2c.
3a.
3e.
4d.
4a.
3b.
4c.
3c.
3d.
3f.
4b.
You have now completed the installation of your fixture,
enjoy.
Remove the fixture from its original packaging. Remove
the mounting plate (1c) from within the canopy (2a) and
attach it to the electrical junction box (1a), using the two
screws (1d) provided in the hardware package.
Attach the canopy backplate (2a) to the mounting plate.
IMPORTANT: if your connecting this product to a junction
box (3a) skip this paragraph and follow the instructions in
the next paragraph 3. First attach all wiring (1b) with the
provided marrets (white to white “N”, black to black “L”,
ground to ground “G”). Now direct the canopy backplate
(2a) onto the mounting plate (1c). With the canopy
backplate seated on the mounting plate, secure with all
four set screws (2c) turning clockwise.
1.
2.
3.
IMPORTANT: To prevent moisture from
entering the outlet box and causing a short,
seal around the top and side perimeter
between the fixture and the wall surface with
weather resistant caulking (see illustration
3). The space at bottom should be left
un-caulked to prevent moisture build-up.
4.
illustration 3
caulking
illustration 2
illustration 1
IMPORTANT: if you’re connecting this product to a junction
box (3a) follow (illustration 2) First, using the two screws
(1d) connect the mounting plate (3d) to the junction box
(3a). Now thread the lead wires from the fixture through the
nut (4a), canopy (4b), cover plate (3f) and through the
centre bolt and attach all wiring (3b) with the provided
marrets (white to white “N”, black to black “L”, ground to
ground “G”). Next, align the cover plate (3f) and canopy
(4b) to the centre bolt (3c) and secure with nut (4a) . With
the canopy backplate seated on the mounting plate, secure
the fixture (4d) with all four set screws (4c) turning
clockwise.