Installation Guide

19054 28th Avenue Surrey, BC Canada V3z6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
INSTALLATION SHEET
VL10323
LED Vanity Lamp
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
You have now completed the installation of your fixture,
please enjoy.
1.
2.
3.
With the fixture removed from its original packaging (see
reverse side of this sheet). secure the canopy (2a) to the
fixture (2d) using the four screws (3a). See Illustration_01.
20161214
Attach the mounting plate (1c) to the gang box (1a) using
screws (1d). Connect all wiring with the provided wire nuts
(1b) (white to white “N”, black to black “L”, ground to ground
“G”). Using the set screws (2b) secure the canopy
backplate (2a) to the anchor plate turning clockwise until
secure.
1c.
1d.
1b.
1a.
2a.
2b.
illustration_01
2b.
2a.
2d.
3a.
Backplate for Single Gang Box is Optional (SOLD
SEPARATELY)