Installation Guide

2b.

1c.

1a.

2a.

1d.

1b.

1e.

19054 28th Avenue Surrey, BC Canada V3S 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

W: kuzcolighting.com

20160527

Remove the fixture from its original packaging. Remove the

mounting plate (1c) from within the canopy backplate (2a)

by unthreading decorative nuts (2b). Attach the mounting

plate(1c) to the electrical junction box (1a), using screws

(1e) provided in the hardware package.

Attach the canopy backplate to the mounting plate. First

First connect all wires correctly G ground to ground, N

neutral wire (white to white), L live wire (black to black) with

provided marettes (1b) from the hardware package. Now

place the canopy (2a) onto the mounting plate (1c). As

you move the canopy, align the holes to the threaded

studs (1d) on the mounting plate (1c). Secure the canopy

by threading in the decorative nuts (2b).

You have now completed the installation of your fixture, enjoy.

INSTALLATION SHEET

VL13424

LED Vanity Light

START FROM HERE

•

Make sure power is completely off at the fuse box.

•

Have your fixture installed by a qualified licensed electrician

•

Prepare everything in a clear area.

•

Wear gloves at all times during this installation.

•

Read instructions carefully before you start assembly.

•

Keep this instruction sheet for future reference.

Technical Support: 1-877-452-6858

Please Note:

• All Kuzco LED fixtures come with pre-wired LED module(s).

• Unless instructed to do so, please do not touch any part of the LED module(s) as any

unnecessary contact with the module could cause permanent damage.

• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.