Installation Guide

2b.

2c.

2a.

1d.

INSTALLATION SHEET

VL17024

LED Vanity Light

START FROM HERE

•

Make sure power is completely off at the fuse box.

•

Have your fixture installed by a qualified licensed electrician

•

Prepare everything in a clear area.

•

Wear gloves at all times during this installation.

•

Read instructions carefully before you start assembly.

•

Keep this instruction sheet for future reference.

Technical Support:

1-855-855-8926

Please Note:

• All Kuzco LED fixture comes with pre-wired LED module(s).

• Unless instructed to do so, please do not touch any part of the LED module(s) as any

unnecessary contact with the module could cause permanent damage.

• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.

Remove the fixture from its original packaging. Remove the

mounting crossbar (1c) from the canopy (2b) by unthreading

two screws (2a) with allen key (2a). Attach the mounting

crossbar (1c) to the electrical junction box (1a), by using

screws (1d) provided in the hardware package.

Attach the canopy to the mounting plate. First connect all

wires correctly G ground to ground, N neutral wire (white to

white), L live wire (black to black) with provided marrettes

(1b) from the hardware package. Now place the canopy

(2b) onto the mounting crossbar (1c). As you move the

canopy, align the side holes to the holes on the mounting

crossbar (1c), and secure the canopy by two screws (2a).

You have now completed the installation of your fixture, enjoy.

19054 28th Avenue Surrey, BC Canada V3Z 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

W: kuzcolighting.com

20200130

1a.1c. 1a.1b.