Installation Guide
2b.
1c.
1a.
2a.
1d.
1b.
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20160527
INSTALLATION SHEET
VL17524
LED Vanity Light
START FROM HERE
•
Make sure power is completely off at the fuse box.
•
Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
•
Wear gloves at all times during this installation.
•
Read instructions carefully before you start assembly.
•
Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
Remove the fixture from its original packaging. Remove the
mounting plate (1c) from within the canopy (2a) by unthreading
the four screws (2b). Attach the mounting plate (1c) to the
electrical junction box (1a), using screws (1d) provided in the
hardware package.
Attach the canopy to the mounting plate. First connect all wires
correctly G ground to ground, N neutral wire (white to white), L live
wire (black to black) with provided marettes (1b) from the
hardware package. Now place the canopy (2a) onto the mounting
plate (1c). As you move the canopy align the holes to the holes
on the mounting plate (1c). Secure the canopy (2a) to the
mounting plate (1c) by threading in the four screws (2b)(top and
bottom).
You have now completed the installation of your fixture, enjoy.
1.
2.
3.