Installation Guide

19054 28th Avenue Surrey, BC Canada V3z6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
INSTALLATION SHEET
WS10336
LED Lamp Wall Sconce
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
20170209
Connect all wiring with the provided wirenuts (1b) (white to
white “N”, black to black “L”, ground to ground “G”). Now
connect the anchor plate (2a) to the mounting plate (1c)
using the screws (2b) provided. Now push the canopy
backplate (2d) onto the anchor plate (2a). Using the two set
screws (2c) thread the canopy backplate to the anchor plate
turning clockwise until secure.
1.
2.
Remove the fixture from its original packaging. Remove
the mounting plate (1c) and anchor plate (2a) from within
the canopy (2c) by loosening the two set screws (2d).
Attach the mounting plate (1c) to the electrical junction
box (1a), using the two screws (1d) provided in the
hardware package.
You have now completed the installation of your fixture,
please enjoy.
3.
1c.
2a.
1b.
1a.
1d.
2b.
2c.
2d.