Installation Guide

19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
INSTALLATION SHEET
LED Lamp Wall Sconce
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
1.
2.
3.
WS10423
20170209
Attach the canopy (2a) with the bridge (2c) to the mounting
plate (1a) on the wall. First, attach all wiring with the provided
marettes (1b) (white to white “N”, black to black “L”, ground
o ground “G’). Now attach the canopy (2a) to the mounting
plate (1a) (see illustration_02) by tightening the two set
screws (2a). You can now install the fixture (2e) onto the
canopy (2a) by tightening the four set screws (2d) (top and
bottom) using the allen key provided in the hardware package.
You have now completed the installation of your fixture,
enjoy.
illustration_02
Remove the fixture from its original packaging. To change the
canopy, remove the large canopy by loosening the two
screws (1d). Separate the bridge (2c) from the large canopy.
Attach the narrow canopy (2a) to the bridge (2c) using the
two screws (1d). Attach the mounting plate (1a) to the single
gang box using the two screws (1c) provided in the hardware
package.
2e.
1b.
1a.
2b.
1c.
1d.
2a. 2c.
2d.
2c.
1d.
illustration_01
Backplate for Single Gang Box is Optional (SOLD
SEPARATELY)