Installation Guide

1.
2.
Remove the fixture from its original packaging. Next,
remove the mounting plate (1c) from within the canopy
(2a) by un-threading the two screws (1e). Attach the
mounting plate (1c) to the electrical junction box (1a) by
using the two screws (1d) provided in the hardware
package.
Secure the mounting plate (1c) to the wall with additional
screws (1g) and anchors (1f).
You are now ready to mount the canopy. First connect
all wires correctly black to black “L”, white to white “N”
and the ground wire with provided marrets (1b) from
the hardware package. Align the canopy (2a) to the
mounting plate (1c) up against the wall. Secure the
canopy by using the two screws provided (1e).
You have now completed the installation of your fixture,
enjoy.
3.
4.
1a.
1f.
1g.
1b. 1c. 1e.1d. 2a.
INSTALLATION SHEET
WS16116
LED Wall Sconce
START FROM HERE
Please Note:
All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
Make sure power is completely off at the fuse box.
Have your fixture installed by a qualified licensed electrician
Prepare everything in a clear area.
Wear gloves at all times during this installation.
Read instructions carefully before you start assembly.
Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W
20181121
: kuzcolighting.com

Summary of content (1 pages)