Installation Guide

INSTALLATION SHEET
LP18260
LED Linear Pendant
START FROM HERE
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20220322
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all time during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
Please Note:
• This Kuzco LED fixture comes with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage
• Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
• 120V input
1. Remove fixture from its original package
2. Pull magnetic plate (2a) off bottom of
canopy (1c) to gain access
3. Attach canopy (1c) to electrical junction
box (1a) using screws provided (1d) in
hardware package
4. To change fixture height, push and hold wire
gripper (2g), slide wire to desired length and
then release wire gripper (2g) to secure
5. Make proper electrical connections (black to
hot “L”, white to neutral “N”, ground to
“GND”) with wire nuts (1b) provided in
hardware package
6. Remove tape (1f) off the driver and insert
driver inside canopy (1c)
7. Close canopy (1c) by re-attach magnetic
plate (2a), make sure no electrical wires or
support cables are in the way
1a.
1c.
1b.
1d.
2a.
1e.
1f.
2g.