Installation Guide

INSTALLATION SHEET
PD19804
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W
20220118
: kuzcolighting.com
LED Pendant
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
1.
2.
3.
4.
Remove the fixture from its original packaging. Next, remove
the mounting plate (1c) from the canopy (2a) by removing
the screws (2b). Attach the mounting plate (1c) to the
electical junction box (1a) using the two screws (1d) provided
in the hardware package.
Install the glass (4b) to the LED module (4a). Next, thread
the metal tube (3e) through silicon (3d), glass (3c), silicon
(3b) to the nut (3a). [Caution: Do not tight the glass by metal
too hard]. Before you mount canopy to the mounting plate,
select the desired length you would like the fixture to hang
down from the ceiling. To set fixture hanging height, simply
push in the sleeve (2c) at the canopy.
Make proper electrical connections (black to hot “L”,
white to neutral “N”, ground to “GND”) with wire nuts (1b)
provided in hardware package and place driver (4a) inside
canopy (2a). Attach the canopy (2a) to the mounting plate
(1c) and secure with screws (2b).
You have now completed the installation of your fixture, enjoy.
1a.
1b.
1c.
1d.
2a.
2c.
2b.
4a.
3a.
3c.
3d.
3e.
4a.
4b.
3b.
Please Note:
• This Kuzco LED fixture comes with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage
• For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
• 120V input