Installation Guide

INSTALLATION SHEET
PD28515
Ceiling LED Pendant
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20230109
1a.
1b.
1c.
1e.
2a.
2b.
2g.
3b.
4a.
3c.
3e.
3d.
3a.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Remove fixture from its original package
Separate mounting plate (1c) from canopy (2a) by
removing canopy screws (2b)
Attach mounting plate (1c) to electrical junction box
(1a) using junction box screws provided (1e) in
hardware package
To change fixture height, push and hold wire gripper
(2g), slide wire to desired length and then release wire
gripper (2g) to secure
Make proper electrical connections (black to hot “L”,
white to neutral “N”, ground to “GND”) with wire
nuts (1b) provided in hardware package and place
driver (4a) inside canopy (2a)
Attach canopy (2a) to mounting plate (1c) with canopy
screws (2b)
Attach rod (3a) to fixture (3b) by threading clockwise
Attach glass (3c) to fixture (3b) with decorative bar
(3e) and secure with screws (3d)
Fine tone wire length if necessary, by push and hold
wire gripper (2g) and then adjust wire to desired
length
START FROM HERE
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all time during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
Please Note:
• This Kuzco LED fixture comes with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage
• Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
• 120V input