Installation Guide

INSTALLATION SHEET
PD62014
Ceiling LED Pendant
START FROM HERE
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20210401
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all time during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
Please Note:
• This Kuzco LED fixture comes with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required
• 120V input
1. Remove fixture from its original package
2. Separate mounting plate (1c) from canopy (2a) by
removing decorative nuts (2c)
3. Align mounting plate screws (1d) to desired orientation,
and then attach mounting plate (1c) to electrical junction
box (1a) using screws provided (1e) in hardware
package
4. Run the wires (2e) through the cover washer (3g), washer
(3f), gasket (3e), glass shade (3a) and let the shade (3a)
rest on LED module (3b). Place the top cap (3d), followed
by the connector (3c) to the LED connector (3h) by
threading clockwise. Run wires (2e) through all the
components
5. Connect all rods together (2d) by threading clockwise into
the LED connector (3h) up to the canopy (2a). Make sure
to run the wires (2e) through the rods up to the canopy
6. Make proper electrical connections (black to hot “L”,
white to neutral “N”, ground to “GND”) with wire nuts
(1b) provided in hardware package
7. Align and insert mounting plate screws (1d) through
holes on canopy (2a), secure with decorative nuts (2c)
3a.
3c.
3d.
3e.
3f.
3g.
3h.
3b.
1a.
1b.
1c.
1d.
1e.
2a.
2c.
2d.
2e.