Instructions / Assembly

INSTALLATION SHEET
VL18524
LED Vanity Light
START FROM HERE
Please Note:
• This Kuzco LED fixture comes with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage
• For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
• 120V input
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all time during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
1. Remove fixture from its original package
2. Separate mounting plate (1c) from canopy (2a) by
removing decorative nuts (2c)
3. Align mounting plate screws (1d) to desired orientation,
and then attach mounting plate (1c) to electrical junction
box (1a) using junction box screws (1e) provided in
hardware package
4. Make proper electrical connections (black to hot “L”,
white to neutral “N”, ground to “GND”) with wire nuts
(1b) provided in hardware package and then place
driver (4a) inside the junction box (1a)
5. Align and insert mounting plate screws (1d) through
holes on canopy (2a), secure with decorative nuts (2c)
1a.1b.4a.1c.1e.
2c.
2a.
1d.
20220506