Instructions / Assembly

INSTALLATION SHEET

WS10324

LED Lamp Wall Sconce

START FROM HERE

Please Note:

• All Kuzco LED fixtures come with pre-wired LED module(s).

• Unless instructed to do so, please do not touch any part of the LED module(s) as any

unnecessary contact with the module could cause permanent damage.

• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.

• 120V input

Connect all wiring with the provided wire nuts (1b) (white to

white “N”, black to black “L”, ground to ground “G”). Now

connect the anchor plate (2a) to the mounting plate (1c)

using the screws (2b) provided. Now push the canopy (2c)

onto the anchor plate (2a). Using the two set screws (2d)

thread the canopy backplate to the anchor plate turning

clockwise until secure.

Remove the fixture from its original packaging. Remove

the mounting plate (1c) and anchor plate (2a) from within

the canopy (2c) by loosening the two set screws (2d).

Attach the mounting plate (1c) to the electrical junction

box (1a), using the two screws (1d) provided in the

hardware package.

You have now completed the installation of your fixture,

please enjoy.

19054 28th Avenue Surrey, BC Canada V3Z 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

W: kuzcolighting.com

20210702

• Make sure POWER is COMPLETELY OFF at the fuse box

• Have your fixture installed by a qualified licensed electrician

• Prepare everything in a clear area

• Wear gloves at all times during this installation

• Read instructions carefully before you start assembly

• Keep this installation sheet for future reference

Technical Support: 1-855-855-8926

1c.

2a.

1b.

1a.

1d.

2b.

2c.

2d.