Manualshelf

Installation Guide

ManualsBrandsKwikset ManualsDeadboltsSmartCode 915 Touchscreen Satin Nickel Single Cylinder Electronic Deadbolt Featuring SmartKey Security
1234
Parts in the box
Latch
Strike
“B” is not included. If needed,
please contact Kwikset to order
a drive-in latch for your lock.
Adapter
Ring
Keys
Exterior
Touchscreen
Mounting
Plate
Fasteners
SmartKey
Tool
Allen
Wrench
Interior
Assembly
A
B
EK
LM
F
J
G
C
D
H
A
A
N (2x)
A
B
B
B
B
A
1 / 4
ENGLISH
61055 / 01
Installation and User Guide
If drilling a new door, use the supplied template and the complete
door drilling instructions available at www.kwikset.com/doorprep.
Note: Additional door preparation may be
required for doors with 11/2" (38 mm) holes.
Consult the deadbolt drilling instructions at
www.kwikset.com/doorprep.
or
backset
Measure to conirm that the hole in
the door is either 21/8" (54 mm) or
11/2" (38 mm).
Measure to conirm that the backset is
either 23/8" or 23/4" (60 or 70 mm).
23/8" or 23/4"
60 or 70 mm
13/8" – 2"
35 – 51 mm
Measure to conirm that the hole in
the door edge is 1" (25 mm).
Measure to conirm that the door is
between 13/8" and 2" (35 mm and
51 mm) thick.
A
A B
C
D
B C D
Is the door edge chiseled?
Are the latch holes centered in the door hole?
Which latch are you installing?Hold the latch in front of the door hole, with the latch
face lush against the door edge.
21/8"
54 mm
11/2"
38 mm
1"
25 mm
YES
YES
NO
NO
Use latch “A”. If the
latch bolt is not already
extended, extend the
latch bolt as shown.
No adjustment is required.
Proceed to next step.
Rotate latch face as
shown to extend latch.
wood
block
Use latch “B” (not included).
If the latch bolt is not
already extended, extend
the latch bolt as shown.
Latch “A” Latch “B”
Kwikset
1-800-327-5625
www.kwikset.com
Required tools
Ruler4 AA Batteries
Hammer Wood block
Phillips head screwdriver
Additional Tools (depending on application)
U (2x)
T (2x)
D
Longer screws
install closest to
the door jamb.
door frame
N
QRS
TU
P
E
Install strike on the door frame.
Make sure the hole in the door frame is drilled a
minimum of 1" (25 mm) deep.
or
chiseled
not
chiseled
or
or
1
Prepare the door and check dimensions
2
Install the latch and strike

Summary of content (4 pages)