Installation Guide
3 / 4
Conrm that the code(s) added in previous step can unlock the door.
7
Test the lock (review normal operation)
Add user codes (25 max)
Make sure the interior
cover is o. Press the
Program button once.
Press Kwikset logo once. Enter user code. A total
of 25 user codes may
be programmed. User
codes should be 4 to 8
digits in length.
Press Kwikset logo once.
A C D E
During programming, if no
button is pressed within 5
seconds, the system will time
out and you will need to restart
the procedure
6
For security reasons, the
first 4 digits of each User
Code must be unique. For
example, you are unable to
program a user code 1-2-3-4-5
as well as user code 1-2-3-4-6.
To lock your door, press the Kwikset logo button. The lock will beep twice and the
Kwikset logo button will ash amber as the deadbolt extends.
To unlock your door, enter the user code. The lock will beep twice and the Kwikset
logo button will ash green as the deadbolt retracts.
BA
Press number 1.
B
Note: After the rst User Code is created, the latch
bolt will automatically retract and extend to learn
the locking and unlocking direction of the door.
The Kwikset logo will indicate success or failure.
GREEN: Success RED: Unsuccessful
Before you can lock and unlock the door, a User Code must be created. Refer to Step 6 for instructions how to create a User Code.
Adding a One-time User Code
8
Delete a Single User Code
9
1.
Remove interior cover.
Press programming
button.
2.
Press number 7.
4.
Enter the one time
user code.
5.
Press the Kwikset logo
button.
3.
Press the Kwikset logo
button.
Up to 5 One-time User Codes can be saved. One-time User Codes should be 4 to 8 digits in length.
The One-Time User Code will be deleted automatically after it is used. The same One-Time User
Code can be created again after it’s used.
1.
Remove interior cover.
Press programming
button.
2.
Press number 2.
4.
Enter the user code
you want to delete.
7.
Press the Kwikset
logo button again.
6.
Enter the user code
being deleted again.
5.
Press the Kwikset
logo button.
3.
Press the Kwikset logo
button.
If unsuccessful:
Make sure you entered the
same user code in steps 4
and 6.
Test code while the door
is open. Test the User Code
to make sure it no longer
unlocks the door.
If a button is not pressed within 5 seconds, the system will time out, and you will need to
restart the procedure.
Delete ALL User Codes
10
1.
Remove interior cover.
Press programming
button.
2.
Press number 4.
4.
Press number 4.
5.
Press the Kwikset logo
button.
3.
Press the Kwikset logo
button.
Note: Keypad locking function will be disabled when User Codes are deleted. The lock
can only be operated manually by a key during this time.
Enable/ Disable Audio
11
1.
Remove interior cover.
Press programming
button.
2.
Press number 5.
3.
Press the Kwikset logo
button.
Note: LED status indicator will still function once audio is disabled. Repeat the
programming steps to enable the audio.