67609-001 Re Vol Parts List [OCT Mounting | Adapter Exterior Assembly Interior Assembly Plate Ring | HALO TT WI-F TOUCHSCREEN SMART LOCK Latch A For Latch / Strike For Lock Installation and User Guide Rilke oat Sadie A854 Required tools [ed CET CE — 8 Ruler Phillips head screwdriver Thickset A678 a mos | seen 18003275625 Additional Tools {depending on application) wwwiwiksetcorm = ph bom Hammer ‘Wood block Chisel fats yur} Note: Additional door preparation may be required for doors with 11/2 G8 mm) holes.
Adapter Ring Is required Adapter Ring Is not for installation, Install on needed for Installation Exterior Assembly. and may be discarded. oO Remove the interior cover from the Interior assembly. Make sure turn piece shafts rotated as shown. It tun piece shaft is not oriented correctly, put the cover back on and Notate the plectrum as shown instep C. 'Q Do not install batteries until step.
Once the door handing process is complete, the touchscreen will Indicate success or failure. Falls. dashing check mark flashing x" ‘symbol and single pattern column of digits If the touchscreen indicates a failure, aka sure the lock interior and batteries are correctly installed. / Ensure correct polarity. Perform step 58 again. For best results, use new, non-rechargeable Alkaline batteries only.
Reference Guide Smart Code at a Glance System Alerts Alert Ramon Solution “X" pattern flashes once | One incorrect code ’ Exterior Interior (cover removed) with one beep®. entered. Re-enter code. *X" patter flashes No user code Program at least one three times with three | Jo armed. user code. Battery pack “X" pattern flashes red | Three incorrect codes Re-enter code after 60 times with 15 beeps® | entered. second keypad lockout. Touchscreen Button "A" Button Check mark Lock Simultaneously five Low battery.